2015-09-24 09:35:45

冷库安装注意事项及冷库故障排除
The installation of cold storage and the trouble shooting of cold storage
我们在使用冷库的过程中难免会出现一些小的故障，如果自己会一点简单的故障排除，就可以在最短的时间内排除故障，就会减少损失。下面济南鼎盛制冷就给大家介绍一些组合冷库维修知识!
In the process of using the cold storage, we will inevitably have some minor faults, if they will be a little simple troubleshooting, you can rule out the fault in the shortest time, it will reduce the loss. Below to introduce some of the combination of cold storage maintenance knowledge!
1、冷库设备初期运转机组:要经常观察压缩机的油面及回油情况及油的清洁度，发现油脏或油面下降要及时解决，以免造成润滑不良。
1, the early operation of cold storage equipment: To observe the compressor oil and oil recovery and oil level, and found that the oil is dirty or oil surface drops to be solved in time, lest cause lubrication.
2、组合冷库不制冷或制冷效果差。检查制冷机的冷凝器上是否脏。检查库内蒸发器上是否积霜过厚。检查制冷剂是否渗漏(用肥皂水涂在管路连接处，有气泡生成说明制冷剂渗漏)。并请组合冷库工程人员补充制冷剂并对渗漏处进行处理。检查组合冷库门的密封是否完好并排除之。检查组合冷库的制冷机是否工作。检查冷库的电脑控制器的参数设定是否正确并重新组合冷库门安装。检查冷库的控制器是否失灵并更换之。检查库内堆放物品是否留有足够的间隙并疏通之。
2, the combination of cold storage refrigeration or cooling effect is poor. Check whether the condenser of the refrigerator is dirty. Check the evaporator in the reservoir is too thick. Check if the refrigerant is leaking (with soap and water on the line, there is a bubble in the refrigerant leakage). And the combination of cold storage engineering personnel to add refrigerant and the leakage of treatment. Check the sealing of the combined cold storage door is intact and excluded. Check whether the refrigeration machine of the combined cold storage. Check the parameters of the computer controller of the cold store and set up the correct and re combined cold storage door. Check that the controller of the cold store is out of order and replaced. Check whether the storage of goods in the warehouse has enough space and clear the.
3、经常观察冷库设备的心脏压缩机运行状态，检查其排气温度，在换季运行时，要特别注意系统的运行状态，及时调整系统供液量和冷凝温。
3, often observed in cold storage equipment of heart operation condition of the compressor, check the exhaust temperature, when change garments according to the operation to pay special attention to the running state of the system, timely adjustment of system supplying liquid volume, and the condensation temperature.
4、组合冷库门启动频繁或长时间不启动或长时间开机不停止或库温不到就停机。
4, the combination of cold storage door to start a long time or a long time does not start or a long time to start the boot does not stop or the library temperature is not on the stop.
A、检查冷凝器上是否有污物，散热不好会导致制冷机冷凝压力过高，为了保护压缩机，在压力控制器的作用下机器停止运转，等到散热良好后，按一下压控器上黑色复位按扭，机器即可自动恢复运行。
If there is dirt on the A, check the condenser, heat is not good will lead to condenser pressure is too high, in order to protect the compressor, pressure controller in the machine stops running, until a good heat dissipation, click pressure control device on the black the reset button, machine can automatically restore complex operation.
B、控制器的参数设定有误，重新设定即可。
B, controller parameter settings are wrong, re set can be.
C、制冷不好，请参考故障。
C, refrigeration is not good, please refer to fault.
D、温控失灵。
D, temperature control failure.
E、电器损坏。
E, electrical damage.
5、平时应通过观察仪表的变化、听机器运转的声音、摸机器的温度变化等方法观察压缩机的运行状态。发现压缩机有串气等现象应及时修理或更换。
5, usually by observing the changes of the instrument, the sound of the machine operation, and the temperature of the machine to observe the operation state of the compressor. There is the phenomenon that the compressor leakage should be promptly repaired or replaced.山东冷库造价
6、库内照明灯不亮。请检查开关是否失灵，灯泡是否损坏。检查时要截断电源，安装灯罩时要注意灯的防水。
6, the library is not bright lights. Please check if the switch is out of order. To cut off the power when the inspection, to pay attention when the lamp is installed.
7、组合冷库门关闭不严密，请调节库门上的合页和门锁与库体之间的间距。
7, a combination of cold storage door does not close off, please adjust the spacing between the hinge and the lock body and the door of the library.
8、我们应实行定期维修和日常维护，保持压缩机运行的高效率。
8, we should carry out regular maintenance and routine maintenance, to maintain the high efficiency of the compressor.

Ji'nan packaging design and printing

本文由济南鼎盛制冷公司提供。

上一条:冷库安装、使用过程中保养注意事项
下一条:我国冷藏车市场潜力大