2018-01-10 18:11:12

1、冷库不制冷或制冷效查制冷机的冷凝器上是否脏。检查库内蒸发器上是否积霜过厚。检查制冷剂是否果差。检渗漏(用肥皂水涂在管路连接处，有气泡生成说明制冷剂渗漏)。并请专业人员补充制冷剂并对渗漏处进行处理。
1. Whether the refrigerators are not refrigerated or the refrigerators are dirty in the condenser. Check whether the frost is too thick on the evaporator in the library. Check whether the refrigerant is bad. Check the leakage (with soapy water on the pipe connection, there is bubble generation to explain the refrigerant leakage). And the professional staff are invited to supplement the refrigerant and treat the leakage.
检查冷库门的密封是否完好并排除之。检查冷库的制冷机是否工作。检查冷库的电脑控制器的参数设定是否正确并重新调整。检查冷库的控制器是否失灵并更换之。检查库内堆放物品是否留有足够的间隙并疏通之。
Check whether the seal of the cold storage door is in good condition and exclude it. Check whether the refrigerator is working or not. Check whether the parameters of the computer controller in the cold storage are correct and readjusted. Check whether the controller of the cold storage is out of order and replaced. Check whether there is enough clearance in the warehouse and dredge it.

2、检查电源：配电箱上没有电或显示屏不显示。请检查冷库的专用闸是否失灵。

2, check the power supply: there is no electricity or display on the distribution box. Please check whether the special sluice of the cold storage is out of order.
3、机器运转时有异常的噪声，请停机检查，是否是振动引起或机械故障。配电箱里有异常的噪声，这是交流接触器发出的声音，是由于接触器的运动部件局部不灵活，请断电后来回按一下接触器的吸铁即可消除噪声。
3, the machine operates with abnormal noise, please stop and check whether it is a vibration or a mechanical failure. There is abnormal noise in the distribution box, which is the voice produced by the AC contactor. It is because the moving parts of the contactor are not flexible. Please turn off the electricity and then press the contact iron to eliminate the noise.
4、制冷机启动频繁或长时间不启动或长时间开机不停止或库温不到就停机。检查冷凝器上是否有污物，散热不好会导致制冷机冷凝压力过高，为了保护压缩机，在压力控制器的作用下机器停止运转，等到散热良好后，按一下压控器上黑色复位按扭，机器即可自动恢复运行。
4, the refrigerator starts frequently or does not start for a long time or does not stop for a long time or does not stop when the temperature is not available. If there is dirt check on the condenser, the heat is not good will cause the condenser pressure is too high, in order to protect the compressor, the machine in the pressure under the control of stop, wait for good heat, press the button on the black voltage controller reset, automatic recovery operation of the machine can be.
5、合闸后冷库配电箱没有反应，而三相电正常。请检查零线，是否有220V电压。冷库的零部件(各种阀件、控制器)都已设定好，没有用户需要调节的零件。
5. The distribution box of cold storage is not reacted after closing, and the three-phase electricity is normal. Please check the zero line, whether there is a 220V voltage. The parts of the cold storage (all kinds of valves and controllers) have been set, and there is no part to be adjusted by the user.
本文由山东冷库造价为您提供，我们的网站是:http://www.sddslk.com我们将以全心全意的热情为您提供更优质的服务，欢迎您的访问！
This article will provide you with the cost of Shandong cold storage. Our website is: http://www.sddslk.com, we will provide you with better service with wholehearted enthusiasm, welcome your visit.

上一条:医药冷库不制冷或制冷效果差的原因
下一条:食品冷库采用双级压缩机的好处