2016-04-13 13:30:51

介绍冷库蒸发器的安装规范事项：
Introduced the installation of the refrigerator evaporator specification items:
1、吊装注意：蒸发器进风口不能对着冷库库门，蒸发器最好吊放在冷库最长端，蒸发器出风口最好不要对着门，（蒸发器取位居中，便于均恒库温及维修）。医药冷库
1, hoisting note: evaporator air inlet can't to the refrigerator door, evaporator best hanging on the side, the longest refrigerator evaporator outlet had better not to the door, (take in the evaporator, facilitate both constant temperature and maintenance).
2、安装内容：先把吊装螺丝孔开好，并开好铜管及电线孔，后二孔要修整以防快口留下隐患，自配排水管的蒸发器背面与立板定位为 300MM ，蒸发器排水孔与立板预先安好的排水孔位垂直，两者间高差为 250MM 。
2, installation content: the lifting screw holes open first, open good copper pipe and wire hole, and after two hole to repair in case of fast mouth left hidden trouble, since with a drain on the back of the evaporator and vertical plate positioning is 300 mm, evaporator and drain board be just fine a vertical drain holes in advance between the elevation difference is 250 mm.
如是冷冻库，排水管内穿排水电热丝，排水电热丝发热部位，只能伸到库板内 50MM 处，排水管外部保温处理，冷藏不需电热丝，其它相同。

Heating wire, the freezer, the drainage tube wear drainage, drainage heating wire heating parts, can only be stretched to the base plate within 50 mm, drainage pipe external heat preservation processing, cold storage without heating wire, the other is the same.

本文由医药冷库设备有限公司整理发表提供，详情请关注公司网站：http://www.sddslk.com/

上一条:冷库安装的三点注意事项
下一条:介绍防爆冷库的三点设计要求